How to configure via the printer's control panel

EIO - Hewlett-Packard

Refer to your printer's manual on how to operate the control panel.

1. Power printer on.
2. Press the MENU key to the right a number of times until the control panel shows: [EIO #, LinkCom EIO]
3. Enable TCP/IP:

   [EIO #, LinkCom EIO] => [CFG TCPIP=YES/NO]

4. Set the IP address:

   [IP BYTE1 = xx] =>
   [IP BYTE2 = xx] =>
   [IP BYTE3 = xx] =>
   [IP BYTE4 = xx]

5. Set the subnet mask:

   [SM BYTE1 = xx] =>
   [SM BYTE2 = xx] =>
   [SM BYTE3 = xx] =>
   [SM BYTE4 = xx]

6. Set the gateway:

   [GW BYTE1 = xx] =>
   [GW BYTE2 = xx] =>
   [GW BYTE3 = xx] =>
   [GW BYTE4 = xx]

7. Press GO to set the printer ready again.

The '#' is the number of the socket holding the PrintServer.

ISP - Lexmark

Refer to your printer's manual on how to operate the control panel.

1. Power printer on.
2. Press the MENU key to the right a number of times until the control panel shows: [NETWORK MENU].
3. Enable the TCP/IP network protocol:

   [NETWORK MENU] => [NETWORK OPTION #] =>
   [LinkCom xx MENU #, TCP/IP] => [TCP/IP, Enable TCP/IP]

4. Set the IP address:

   [LinkCom xx MENU #, TCP/IP] => [TCP/IP, Default IP. Addr.]

5. Set the subnet mask:

   [LinkCom xx MENU #, TCP/IP] => [TCP/IP, Default SM]

6. Set the gateway:

   [LinkCom xx MENU #, TCP/IP] => [TCP/IP, Default Gateway]

7. Press GO to set the printer ready again.

The '#' is the number (1-3) of the socket holding the PrintServer.