Quick Guide

Static electricity can damage the interface. You should either wear an antistatic wrist wrap, or frequently touch the metal surface of the printer.

Install interface in printer

1. Make sure no power cord is connected to the printer.
2. Locate the printer's interface slot by way of the printer's manual.
3. Remove the plate covering the printer’s interface slot.
4. Insert the interface in the slot as described in the printer's manual.

Network installation

1. Make sure no power cord is connected to the printer.
2. Connect network cable to the RJ45 port on the rear panel of the interface. Power on the printer.
3. The complete Installation Guide will be printed.
   
   Note: If nothing is printed, please check that the printer is on-line and not in an error condition (i.e. paper out, toner low, etc.).

Generate settings printout

1. Press the TEST button on the back of the PrintServer.